FoamDaddy Logo

24hr WORLDWIDE Shipping!

(480) 283-7000

Southwest Airlines

You receive expedited service and your shipment is guaranteed to reach its final destination within 24 hours of the time it was tendered. Count on our expedited Priority Freight Service to meet your shipping needs.

Setup Operation & Maintenance Instructions

  • Hang the foam machine using a chain from something sturdy such as a tree, basketball hoop, lighting trust or anything suitable for 38 lbs.
  • Make sure the machine is set at HIGH/ON position after hanging.
  • Screw one end of a water-hose to the front of the foam machine and the other end to the provided solution pump.
  • Mount the Power Strip away from water and foam with tape, securely. Be sure the power strip is in the OFF position.
  • Plug solution pump into Power Strip.
  • Submerge foam solution pump into container (preferably a 55 gallon drum or large garbage can).
  • Plug the foam machine into the Power Strip.
  • Leaving the solution pump in the 50 gallon drum, fill with 50 gallons of water.
  • Add ½ gallons of Concentrated Foam Party Solution.
  • MIX foam machine solution by gentle bobbing the solution pump up and down for about five minutes or until all the foam machine liquid concentrate is dissolved in the water. (you can feel this with your hand).
  • Turn the power strip ON, within 20 seconds you should have ton's of FOAM. If not RECHECK YOUR STEPS.
  • SUPPORT? (480) 283-7000 or (602) 575-1399.
    • DOES NOT INCLUDE HOSE OR MIXING BUCKET FOR YOUR FOAM SOLUTION. You will need any standard garden hose and a 50 gallon drum or bucket or trash can (easily found at any Wal-Mart.
  • The foam machine requires little maintenance. Follow these steps for long lasting performance:
  • Flush out all foam fluid when done using the foam machine. Run clean water through the foam machine (with fan on and foam bag attached) for 1 minute. This will prolong the life of the foam bag and seals in the pump.
  • Do not let the foam solution pump run without water or fluid in it. This will overheat the seals and cause damage.
  • Prevent foam from entering the back of the foam machine. Do not let the foam machine suck foam into the intake portion. This will cause damage the motor.
  • Do not spray water into the motor. Water will damage electrical windings and reduce bearing life.
  • Keep the solution pump dry when not in use. Empty all water from pump housing before storing the foam solution pump.
  • Always use the suction strainer/filter. This will keep debris out of the pump and nozzle.

Back to top